Components are quickly mounted on the backboard using wing nuts for maximum flexibility in arranging components. Connections between components are wired by the students. (Mounting hardware must be purchased locally).
HVAC Vocational Training Units
Designed for the student with a working knowledge of the theory of refrigeration electrical control systems. Using this trainer, students are required to design a system to match specifications of a particular situation.Item Number:TU-501
Real world experience in troubleshooting wiring, piping and controls of a working air conditioning unit for a whole house.Item Number:TU-206
iConnect Training provides a line of sophisticated training units that greatly aide in the teaching of Heating, Ventiliation, Air Conditioning and Refrigeration. The Residential Air Conditioning Trainer (TU-206) can be purchased with frame assembled or in two parts. If ordered in two parts, the discharge and suction lines will need to be reconnected using the factory-supplied flare fittings and internal gaskets.
Real world experience in troubleshooting wiring, piping and controls of a working air conditioning unit.Item Number:TU-406
TU-406 Residential Heat Pump Trainer gives students hands-on real world experience in troubleshooting wiring, piping and controls of a working air conditioning unit for a whole house.
Students will gain a full understanding of National Electrical Code residential electrical circuits. Through practice, students attain a substantial beginning-level skill and proficiency using tools of the electrical trade.Item Number:TUE-200
iConnect Training has been providing the finest training units to the educational market for over thirty years. They can be found in high schools, colleges, and so on all over the world. With the iConnect TUE-200 Residential Wiring Demonstrator students gain a full understanding of National Electrical Code residential electrical circuits. Through actual practice, students attain a substantial beginning-level skill and proficiency using tools of the electrical trade.
This Residential Wiring Trainer is used to demonstrate electrical principles similar to those found in a residential dwelling.Item Number:TUE-150
This Residential Wiring Trainer is used to demonstrate electrical principles similar to those found in a residential dwelling. It also has provision for extensive switching and connection of lamps and outlets. The trainer has a 24-volt power supply that is used to wire and test all circuits After the instructor has approved wiring, 120VAC can be applied using the key-lock circuit breaker control. The ability to use low voltage for testing and 120VAC for final wiring is a valuable teaching aid.
Consists of an actual single phase compressor with components necessary to demonstrate all common types of controls in refrigeration and air conditioning systems.Item Number:TU-521
The TU-521 Sinlge Phase Compressor Control Board features shut-off valves in suction and pressure lines allow pressures to be varied to operate the low pressure control and high pressure cutout, PSC (permanent split capacitors) and running capacitors are supplied for capacitor (capacitive) start systems...
Real world experience in troubleshooting wiring, piping and controls on a working heat pump unit. The trainer is perfect for introduction to heat pump theory.Item Number:TU-701
The TU-701 Trainer includes a blower unit with evaporator, condenser fan unit, pre-piped suction and high pressure refrigeration tubing is visible for direct observation of the fluid and gas states of the refrigeration cycle; and a 360 page book with lesson plans, question and review section.