HVAC Vocational Training Units

Prior to going out into the field, the student should fully understand the theory and operational or service techniques behind each specific system. Imperial Training has been providing the finest training units to the educational market for over thirty years. They can be found in high schools, colleges, and so on all over the world.

The training units in this catalog represent a wide variety of subjects in the heating, refrigeration and air conditioning industries. The heating and air conditioning training units range from demonstrating simple concepts to illustrating advanced troubleshooting and servicing techniques.

  • Imperial TUE-150 Residential Wiring Trainer
    Imperial TUE-150 Residential Wiring Trainer
    Item Number:

    This Trainer Panel is used to demonstrate electrical principles similar to those found in a residential dwelling. It also has provision for extensive switching and connection of lamps and outlets. The trainer has a 24 volt power supply that is used to wire and test all circuits After the instructor has approved wiring, 115 VAC can be applied using the key-lock circuit breaker control. The ability to use low voltage for testing and 115 VAC for final wiring is a valuable teaching aid.

  • Single Phase Compressor Control Board (TU-521)
    Consists of an actual single phase compressor with components necessary to demonstrate all common types of controls in refrigeration and air conditioning systems.
    Item Number:

    The TU-521 Sinlge Phase Compressor Control Board features shut-off valves in suction and pressure lines allow pressures to be varied to operate the low pressure control and high pressure cutout, PSC (permanent split capacitors) and running capacitors are supplied for capacitor (capacitive) start systems...

  • iConnect Tabletop Heat Pump Trainer (TU-701)
    Real world experience in troubleshooting wiring, piping and controls on a working heat pump unit. The trainer is perfect for introduction to heat pump theory.
    Item Number:

    The TU-701 Trainer includes a blower unit with evaporator, condenser fan unit, pre-piped suction and high pressure refrigeration tubing is visible for direct observation of the fluid and gas states of the refrigeration cycle; and a 360 page book with lesson plans, question and review section.